Table of Contents
Advertisement
Operation
Loading and transporting the machine
< 15°
<17°
Fig. 51: Access ramps
3-24
Safety regulations
• The transport vehicle must be of sufficient size. See
6 "Technical data" for the dimensions and the weight of the machine!
• Remove any mud, snow or ice from the tracks so that the machine can
be safely driven onto the ramps
• Secure the machine against unintentional movement!
– see
Machine shut-down on page 3-21
Danger!
The machine must be loaded and transported properly –
It is essential that you read the safety instructions at the
beginning of this chapter and follow any other safety instruc-
tions relevant in your country!
Load as follows:
Secure the transport vehicle with chocks to prevent it from rolling.
Place the access ramps at the smallest possible angle. Ensure that the
grade does not exceed 15° (27%). Use access ramps with an anti-skid
surface only.
Ensure that the loading area is clear and access to it is not obstructed –
for example by superstructures.
Ensure that the ramps and the tracks of the dumper are free of oil,
grease and ice.
Start the engine of the dumper
Lower tipping trailer
Carefully drive the dumper onto the middle of the transport vehicle.
Stop the engine.
Remove the ignition key (model DT05-D)
Warning!
The manufacturer's warranty shall not apply to accidents or dam-
age caused by loading or transporting.
Accident hazard!
BA DT05 EN - Edition 2.0 * * dt05b330.fm
Chapter
Advertisement
Table of Contents
