Checking The Hydraulic Oil Level; Adding Hydraulic Oil - Wacker Neuson DT05 Operator's Manual

Maintenance

Checking the hydraulic oil level

B
A
Fig. 84: Hydraulic oil level
FULL
Low
Fig. 85: Hydraulic oil level

Adding hydraulic oil

5-18
Proceed as follows:
Park the machine on level ground.
Raise the platform and lock it in the safety position
prop on page 5-1.
Stop the engine.
The dipstick is integrated in the sealing push-in cap B of hydraulic oil
tank A
Check whether the oil level is between MIN and MAX.
Add hydraulic oil if the oil level is lower.
Refill hydraulic oil only with the engine stopped otherwise hydraulic oil will
overflow at the filler opening on the hydraulic oil reservoir.
Add as follows:
Park the machine on level ground.
Raise the platform and lock it in the safety position
prop on page 5-1.
Stop the engine.
Unscrew filler cap B
Use an oil funnel with micro-filter to fill in oil
With the filter insert in place:
Adding hydraulic oil
Check the hydraulic oil level with the dipstick integrated in filler cap B
Add if necessary and check again
Firmly tighten filler cap B by hand.
See Maintenance
See Maintenance
BA DT05 EN - Edition 2.0 * * dt05b520.fm