Advertisement
56
. Attach Horizontal Above Door Trim with right side
piece aligned flush with the top corner of doorway.Leave
1/8" gap between trim pieces, gap will be covered by a
detail plate in Step 70. Attach with 4 - 1 1/2" Finishing
Nails per piece.
57
. Position Porch Ceiling Panels underneath rafters with channels facing downward. To fit with the
rafter spacing, there is a Left and a Right Panel. This is indicated by a sticker on the back of each panel.
The left panel will go onto the left side of the porch roof when viewing the shed from the front.
The corner of the Horizontal Above Door Trim will rest in the first channel of the Porch Ceiling Panel. You
will need a helper to hold the panel in place while you attach with 1 1/2" Finishing Nails (27 per side).
Attach one nail through both ends of each panel strip into the rafters above. It may be helpful to add a
few nails to the center rafter. Attach other panel the same.
Parts (Steps 57)
Porch Ceiling Panels
(1/2" x 44 1/2" x 48 1/2") x 2
Toll Free 1-888-658-1658
Flush with corner
www.outdoorlivingtoday.com
Flush with corner
Approx. 1/8" gap
between trim pieces.
Parts (Steps 56)
Horizontal Above
Door Trim
(1/2" x 3 1/2" x 44") x 2
Flush
Hardware (Steps 57)
N1 - 1 1/2" Finishing Nails
Page 34
Hardware (Steps 56)
N1 - 1 1/2" Finishing
Nails
x 8 total
Corner of Horizontal
Above Door Trim
rests in first channel.
x 54 total
sales@outdoorlivingtoday.com
Advertisement
