26.
Attach the 4 Side Top Plates. The
side top plates are angle cut down the
length. Once again, position top plate on
wall plate so it is flush with inside of wall
plate. Side plate should also be flush with
rear wall plate. Secure with:
4 - 2" screws per rear piece.
1 - 2" screw & 3 - 1 1/4" screws per
front piece.
Parts (Steps 26)
Side Top Plates
(3/4" x 2 1/2" x 67") x 4
Hardware (Steps 26)
S3 - 2" Screws
x 10 total
27
. Position the Front Top Plates on top of Door Header and
front wall panel. There are 2 plates (72" and 19" long). Front top
plates are straight cut on the ends. Once again, the plate will be
flush with inside of top wall framing. Attach with 6 - 2" screws
(4 screws in long and 2 in short plate).
Parts (Steps 27)
Front Top Plates
(3/4" x 2 1/2" x 72" & 19") x 2
Toll Free 1-888-658-1658
Hardware (Steps 26)
S2 - 1 1/4" Screws
x 6 total
www.outdoorlivingtoday.com
3 - 1 1/4" Screws
Hardware (Steps 27)
S3 - 2" Screws
x 6 total
Page 21
4 - 2" Screws
PreDrill!
1 - 2"
Screw
Flush
sales@outdoorlivingtoday.com