Entering the Department ID and Password
When Department ID Management has been set, the department ID and password must be
entered before operating this copier.
NOTE
•
For instructions on setting department IDs and passwords, see 'Setting Department ID and
Password (Department ID Management)', on p. 2-27.
•
If Control Cards are being used, the message "Insert a control card". appears on the touch panel
display. Insert the Control Card into the card slot. (See 'Control Card', on p. 5-72.)
Operations After Turning the Power On
After turning the power on and the copier is ready to make copies, the screen for entering the
department ID and password appears.
NOTE
•
For details on how to turn the power on, see 'Turning On and Off the Copier', on p. 1-16.
1
Press [Dept. ID] and enter the department ID; then press [Password] and
enter the password using
If the password has not been set, proceed to step 2 without entering the password.
The numbers that you enter are displayed as asterisks (*).
NOTE
•
If you make a mistake when entering the department ID or password, press
the correct number.
-
(Number keys).
Entering the Department ID and Password
1
(Clear), then reenter
1-27