005: Ncc Pause Length (Pre-Id Code); 006: Ncc Pause Length (Post-Id Code); 007: Pre-Pause Length At Time Of Ring; 009: Number Of Comparison Digits Of Source Telephone Number And Target Telephone Number - Canon imageRUNNER iR2270 Service Manual

4.4.3 <005: NCC pause length (pre-ID code)>
Use it to set the length of the pause automatically entered between access code and ID code
when the NCC (New Common Carrier) line is used for dialing.
4.4.4 <006: NCC pause length (post-ID code)>
Use it to set the length of the pause automatically entered between ID code and telephone
number of the other party when the NCC (New Common Carrier) line is used for dialing.
4.4.5 <007: pre-pause length at time of ring>
Use it to set the length of the pause used when placing a call.
4.4.6 <009: number of comparison digits of source
telephone number and target telephone number>
Use it to set the number of TSI comparison characters (lower $ characters) for a check on
telephone numbers.
4.4.7 <010: line connection identification length>
Use it to set the time for identifying the line connection. Raise this parameter if errors occur
frequently at time of communication because of the condition of the line.
Memo: Any of the following error codes may be indicated because of the condition of the
line
##005, ##018
The line condition identification time is between when the dial signal is transmitted and
when the line condition is cut for the transmitting party, while it is between when the DIS
signal is transmitted and when the line is cut for the receiving party.
4.4.8 <011: T.30 T1 timer (for reception)>
Set it so that the T1 time may be varied. (The regulations governing the T1 timer vary from
country to country (PTT)).
Chapter 4
0007-5707
0007-5708
0007-5709
0007-5710
0007-5711
0007-5712
4-27