Your Receiver; Default Pin-Code: 0000; Front Panel; Side Panel - THOMSON THS844 User Manual

- If you are going to use external USB HDD (Hard Disk Drive) please consider that the power
specifications might exceed the supported output of your receiver (5 V/800 mA). If so, please
connect your USB HDD to an according external power adapter.
- STRONG cannot guarantee compatibility with all types of USB storage devices.
- It is advised not to store important information on USB storage devices used with the receiver.
Always make backups of data on your USB storage device before using it with this receiver. STRONG
will not take responsibility for any loss of information or circumstances caused by loss of information.
- Please ensure that either the USB device is already formatted to NTFS or FAT32 or format the USB
device via your receiver. Formatting requires entering the PIN code (default 0000)
- STRONG cannot guarantee the playback of all files although extensions are listed, as it depends on
file size, codec, bit rate and resolution.

2.0 YOUR RECEIVER

2.1 DEFAULT PIN-CODE: 0000

2.2 Front Panel

1. Power button
2. P-/P+:
3. LED Display
4. Standby indicator:
5. USB

2.3 Side Panel

1. Smart card slot

2.4 Rear Panel

1. SAT IN
2. S/PDIF (coax.)
3. HDMI
4. TV SCART
5. Ethernet
6. DC POWER

2.5 Remote Control

1. q
2. !
3. 0~9
4. TV/R
5. 
6. FAV
7. 9
8. AUDIO
Switch the receiver to Standby or On
To change channels without using the remote control
Displays channel number, time, videotext page or recording modes
Shows power state of the receiver: Red LED - receiver is in standby
mode
To connect your USB storage device
To insert your HD+ smart card with the golden chip facing down.
To connect to the LNB of your satellite antenna for reception of
satellite broadcast signal
To connect to a digital amplifier or home theatre using a coaxial
cable
To connect to the HDMI input of your TV set using a good quality
HDMI cable
To connect to TV using a SCART cable
To connect to a network switch, router or modem
To connect to the original included main power adapter (Input
~230 V 50~60 Hz/ Output 12 V, 1.5 A DC
Turns the receiver ON/Standby
To turn the sound on or off
Channel number and numeric value input
Toggles between TV and radio mode
No function
To access your favourite channels. Toggles between available
favourite groups
To switch between the last viewed channels
Displays the audio selection menu with selections for available
languages and audio modes
Fig.1
Fig.2
Fig. 3
)
Fig. 4
5