Usage Of External Usb Devices; Your Receiver; Default Pin-Code: 0000; Front Panel - THOMSON THS814 User Manual

The usage of other power adapters may cause damage to the device. Such damage is not covered
under warranty.

1.5 Usage of external USB devices

- It is recommended to use USB 2.0 or higher storage devices. If your device is not compatible to USB
2.0 specifications, multimedia functions or software update might not work properly.
- If you are going to use external USB HDD (Hard Disk Drive) please consider that it might be the
case that the power specifications exceed the supported output of your receiver (5 V/800 mA). If so,
please connect your USB HDD to an according external power adapter.
- STRONG cannot guarantee compatibility with all types of USB storage devices.
- It is advised not to store important information on USB storage devices used with the receiver.
Always make backups of data on your USB storage device before using it with this receiver. STRONG
will not take responsibility for any loss of information or circumstances caused by loss of information.
- For a proper performance with this receiver your USB device must be formatted to FAT32.
- Playback of files cannot be guaranteed although extensions are listed, as it depends on codec, data
bit rate and resolution used (all MPEG codec formats are supported).

2.0 YOUR RECEIVER

2.1 DEFAULT PIN-CODE: 0000

2.2 Front Panel

1. STBY/ON
2. P-/P+
3. IR Sensor
4. Indicator LED
5. USB

2.3 Side Panel

1. Smartcard slot
NOTE:

2.4 Rear Panel

1. SAT IN
2. IR
3. S/PDIF (coax.)
4. HDMI
5. TV SCART
6. Power adapter

2.5 Remote Control

1. q
Switches the receiver ON or into Standby
Changes to the previous/next channel in TV mode
Receives the RCU commands
GREEN indicates that the receiver is currently ON, RED indicates
that the receiver is currently in standby mode
To connect your USB storage device for multimedia or software
update
To insert your valid and activated ORF Digital (Irdeto) smartcard
5 min after switching the receiver to Standby it enters the deep sleep
mode. Within this time the receiver is able to start up quickly. Starting up
from deep sleep takes approx. 45 sec.
To connect to the LNB of your satellite antenna for reception of
satellite broadcast signal
To connect the separately available IR extender
To connect to a digital amplifier or home theatre set
To connect to the HDMI input of your TV set using a good quality
HDMI cable
To connect to your TV set using a SCART cable
To connect to the original included main power adapter (Input 100
~240V 50~60Hz/ Output 12 V DC/ 1,5 A)
Switches the receiver On/Standby
Fig. 1a
Fig. 1b
Fig. 2
Fig. 3
5