Table of Contents
Advertisement
- If you are going to use external USB HDD (Hard Disk Drive) please consider that it might be the
case that the power specifications exceed the supported output of your receiver (5 V/500 mA). If so,
please connect your USB HDD to an according external power adapter.
- We cannot guarantee compatibility with all types of USB storage devices.
- It is advised not to store important information on USB storage devices used with the receiver.
Always make backups of data on your USB storage device before using it with this receiver. We will
not take responsibility for any loss of information or circumstances caused by loss of information.
- For a proper performance with this receiver your USB device must be formatted to FAT32.
- Playback of files cannot be guaranteed although extensions are listed, as it depends on the codec,
data bit rate and resolution (all MPEG codec formats are supported).
2.0 YOUR RECEIVER
2.1 DEFAULT PIN-CODE: 0000
2.2 Front Panel
1. IR Sensor
2. Indicator LED
3. STBY/ON
4. USB
2.3 Rear Panel
1. SAT IN
2. IR
3. Ethernet
4. HDMI
5. S/PDIF (coax.)
6. TV SCART
7. Power adapter
2.4 Remote Control
1. q
2. !
3. OPT
4. TEXT
5. SUB
6.
7. 0~9
8. TV/R
9. AUDIO
10. VOL+/VOL-
11. 9
12. FAV
13. CH+/CH-
Receives the RCU commands.
GREEN indicates that the receiver is currently ON, RED indicates
that the receiver is currently in Standby mode.
Switches the receiver ON or into Standby.
To connect your USB storage device for multimedia functions or
software update.
To connect to the LNB of your satellite antenna for reception of
satellite broadcast signal.
To connect the IR extender (not included)
To connect to to your home network via switch, router or modem.
To connect to the HDMI input of your TV set using a good quality
HDMI cable.
To connect to a digital amplifier or home theatre set.
To optionally connect to your TV set using a SCART cable.
To connect to the original included main power adapter (Input 100
~240 V 50~60 Hz/ Output 12 V DC
Switches the receiver On/Standby
Mutes audio output of the receiver in every mode incl. videotext,
the symbol will not be shown within menu mode
Opens the settings for TV format, aspect ratio and resolution
Opens the videotext if available
Shows the list of DVB-subtitles if available
Gives direct access to mails from your broadcaster
Channel selection or value input
Toggles between TV and RADIO mode
Opens the list of audio languages
Increases/decreases the volume in all modes (with TV picture in BG/
Videotext)
Opens the recently watched channel list or switches between the
two last previously watched channels*
Opens the favourite list selection if previously configured
Channel up/down
Fig. 1
Fig. 2
).
Fig. 3
5
Advertisement
Table of Contents
