Table of Contents
Advertisement
2.0 Your rECEIvEr
2.1 DEfAuLT PIn: 1234
2.2 front Panel
1.
Ir sensor
2.
4 digits display
3.
Mode indicator
4.
uSb
2.3 rear Panel
1.
AnT In
2.
AnT ouT
3.
S/PDIf Coaxial:
4.
hDMI
5.
Tv SCArT
6.
Audio L/r
7.
Power Cord
2.4 remote Control
1.
q
2.
!
3.
PG+/PG-
4.
DTv/vCr
5.
Info
6.
voL+/voL-
7.
MEnu
8.
EXIT
9.
pq
Point your remote control towards this sensor.
Indicates current time in STANDBY mode. Indicates current
channel number in OPERATING mode
RED indicates that the receiver is in STANDBY mode.
GREEN indicates that the receiver is in OPERATING mode
Connector for USB storage devices.
To connect to your antenna for reception of broadcasted signals.
To connect the terrestrial antenna signal to your TV set. This
connection will allow you to watch digital terrestrial programmes
depending on the tuner of your TV and local broadcast
conditions
To connect your receiver to a digital home theatre, AV receiver or
digital audio amplifier.
To connect your receiver with your TV set using an HDMI cable.
To connect your receiver with your TV set using a SCART cable.
To connect your receiver to an analogue audio amplifier.
Your receiver requires a supply voltage of 220~240V AC (Auto-
selectable), 50/60Hz +/-5%. Please ensure the local power
specification meets these requirements before connecting your
receiver to the wall outlet.
Switches the receiver On/Standby
Mutes all audio outputs of the receiver
Page up/down in all list modes
No function
Opens the current channel information; 2x opens the current
event information and 3x the signal information
Increases/decreases the volume level
Opens the main menu, in a menu you will get one step back
Exits from the menu or sub-menu
Menu Off: Change channel to next/previous.
Menu On: Moves the cursor up/down.
Fig. 1
Fig. 2
Fig. 3
P5
YOUR RECEIVER
Advertisement
Table of Contents
