Table of Contents
Advertisement
- Playback of files cannot be guaranteed although extensions are listed, as it depends on
codec, data bit rate and resolution used (all MPEG codec formats are supported).
- Please ensure that either the USB device is already formatted to FAT/FAT32, or format the USB
device via your receiver, refer to chapter <USB> of the user manual available on our website
www.thomsonstb.net for details.
*This user manual describes the full functionality including the recording function and may not be applicable if the
software for recording via USB has not yet been installed.
2.0 YOUR RECEIVER
2.1 PIN code default: 0000
2.2 Front and side panel
1.
q
2.
P-/P+
3.
Remote control sensor:
4.
Standby indicator:
2.3 Rear panel
1.
SAT IN
2.
USB
3.
HDMI
4.
TV SCART
5.
Audio L/R
6.
S/PDIF coaxial
7.
Power connector
2.4 Remote Control
1.
q
2.
!
3.
0-9
4.
TV/R
6
Switch the receiver to Standby or On.
To change channels without using the remote control
Receives the signal from the remote control
Shows power state of the receiver
Green LED - receiver is turned on
Red LED - receiver is in standby mode
To connect to the LNB of your satellite dish for reception
of satellite broadcast signal
For connection of USB device for Multimedia use
To connect to the HDMI input of your TV using a good
quality
To connect to TV using a SCART cable
To connect to an analogue amplifier for stereo audio.
To connect to a digital or home cinema audio amplifier
The receiver requires a wall adapter, mains voltage input
100~240V AC 50~60Hz 12V, 1.5A DC output. Please
check the local power conditions before connecting the
receiver to the mains supply
Turns the receiver ON/Standby
To turn the sound on or off
Channel number and numeric value input
Toggles between TV and radio mode
Fig. 1
Fig. 2
Fig. 3
Advertisement
Table of Contents
