Your Receiver; Pin Code Default: 0000; Front And Side Panel; Rear Panel - THOMSON THS222 User Manual

2.0 Your rECEIvEr

2.1 PIn code default: 0000

2.2 front and side panel

1.
Power button:
2.
P-/P+:
3.
remote control sensor:
4.
LED display:
5.
standby indicator:

2.3 rear panel

1.
sAT In
2.
Ethernet
3.
usb
4.
hDMI
5.
Tv sCArT
6.
Audio L/r
7.
s/PDIf coaxial
8.
Power connector

2.4 remote Control

1.
q
2.
!
3.
fAv
4.
LIsT
5.
AuDIo
6.
9
7.
rED
8.
GrEEn
Switch the receiver to Standby or On.
To change channels without using the remote control
Receives the signal from the remote control
Shows channel number in operation and time in Standby
Shows power state of the receiver: Red LED - receiver is in
standby mode
To connect to the LNB of your satellite dish for reception of
satellite broadcast signal
To connect to a network switch, router or modem
For connection of USB device for Multimedia use
To connect to the HDMI input of your TV using a good quality
HDMI cable
To connect to TV using a SCART cable
To connect to an analogue amplifier for stereo audio
To connect to a digital or home cinema audio amplifier
The receiver requires a wall adapter, mains voltage input
100~240V AC 50~60Hz 12V, 1.5A DC output. Please check the
local power conditions before connecting the receiver to the
mains supply.
Switches the receiver On/Standby
To turn the sound on or off
To access your favourite channels. Toggles between available
favourite groups
Shows the recording list*
Displays the audio selection menu with selections for available
languages and audio modes
To switch between the last viewed channels
Flexible functions in OSD menu and Teletext
Flexible functions in OSD menu and Teletext.
Fig. 1
Fig. 2
Fig. 3
P5
YOUR RECEIVER