Your Receiver; Default Pin: 1234; Front Panel; Rear Panel - THOMSON THC301 User Manual

- It is advised not to store important information on USB storage devices used with the receiver.
Always make backups of data on your USB storage device before using it with this receiver. We will
not take responsibility for any loss of information or circumstances caused by loss of information.
*This user manual describes the full functionality including the recording function and may not be applicable if the software for
recording via USB has not yet been installed.

2.0 YOUR RECEIVER

2.1 DEFAULT PIN: 1234

2.2 Front Panel

1. IR Sensor
2. LED Display
3. Mode Indicator LED
4. Standby/ON button
5. USB

2.3 Rear Panel

1. CABLE IN
operator
2. CABLE OUT
3. HDMI
4. TV SCART
5. S/PDIF (coax.)
6. Power connector

2.4 Remote Control

1. q
2. !
3. 0~9
4. TV/R
5.

6. FAV
7. 9
8. AUDIO
9. INFO
10. EPG
11. p/q
12. tu
13. OK
14. MENU
15.

16. VOL+/VOL-
17. P+/P-
18. LIST
Receives commands from the remote control
Shows channel number and time in standby
RED indicates that the receiver is in STANDBY mode.
Switches the receiver ON or into Standby
To connect your USB storage device.
Connect your receiver to the wall connector provided by the cable
Connect your receiver to another digital receiver or to a TV to keep
using its internal (analogue) tuner (loop through function)
Connect your receiver with your TV set using an HDMI cable.
Connect your receiver with your TV set using a SCART cable.
Connect your receiver to a digital home theatre, AV receiver or
digital audio amplifier.
The receiver requires a wall adapter, mains voltage input 100~240
V AC 50~60Hz 12 V, 0.5 A DC output. Please check the local power
conditions before connecting the receiver to the mains supply.
Switches the receiver On/Standby.
Mutes all audio outputs of the receiver
Enter channel number in TV mode or value input in menu
Toggles between TV or RADIO mode.
No function
Opens the favourite group selection.
One step back in menu or back to previous channel.
Opens the audio language selection*
Opens the current channel information; 2x opens the technical
information about the current channel.
Opens the EPG (Electronic Programme Guide) in TV mode*
Change channel to next/previous. Menu: Moves the cursor up/
down.
Decreases/increases the volume level. Menu: Change settings for
specific menus.
Opens the current channel list in menu: for confirmation
Opens the main menu, in a menu you will get one step back.
Exits from the menu or sub-menu.
Increases/decreases the volume level.
Page up/down in all list modes.
Call the current channel list.
Fig. 1
Fig. 2
Fig. 3
5