Trace Setup; Alarm Setup - Speco O4P25X2 User Manual

Ptz network camera

Hide thumbs Also See for O4P25X2:

Table of Contents



Note: The home position function will be disabled if enabling task setting.

4.4.5 Trace Setup

Go to Dome FunctionTrace Setup menu as shown below:

This function is used to memorize the operation to PTZ, zoom and focus so that repeating operation progress can be realized by

running trace.

Setting Steps:

① Choose the trace number.

② Edit the trace. Enter the trace setting menu. Click "Iris –"to start recording trace. Control the dome movement by direction

buttons and then save the setting. Each trace can record up to 180s. If the time exceeds 180s, the system will automatically save

the operation data and return to the previous menu. In addition, 360 commands can be recorded for each trace at most. If

exceeding 360 commands, the system will automatically save the first 360 commands and then exit the current menu. The

recording time is related to the operating frequency. The more frequent the operation is, the shorter the memory time is.

③ Select "RUN CUR TRACE..." to perform the command.

Go to Dome FunctionAlarm Setup as shown below:

Setting Steps:

① Select Alarm In No.

② Go to "EDIT CUR ALARM IN" menu as shown below.

【ALARM IN CON】:Set the alarm enter type to be Normally Opened (N.O.) or Normally Closed (N.C.) according to the sensor type.

【ALARM IN MODE】:ON, OFF and TIME are optional.

【ALARM CALL】: Call the preset/cruise/trace/scan you need. When the first alarm input happens, the camera will automatically

switch to this preset/cruise/trace/scan to monitor.

【ALARM OVER】:Call the preset/cruise/trace/scan you need. When the alarm trigger is over, the camera will automatically switch to

this preset/cruise/trace/scan to monitor.

【OUTPUT ENABLE】: Select it ON. When alarm input occurs, the camera will output alarm information.

Table of Contents