Ddns; Snmp - Speco O4P25X2 User Manual

Ptz network camera

Table of Contents

1. Check "Enable".

2. Check the IP address and port of the transfer media server in the VMS. Then enable the auto report in the VMS when adding a

new device. Next, enter the remaining information of the device in the VMS. After that, the system will automatically allot a device

ID. Please check it in the VMS.

3. Enter the above-mentioned server address, server port and device ID in the corresponding boxes. Click the "Save" button to save

the settings.

5.6.4 DDNS

If the camera is set up with a DHCP connection, DDNS should be set for accessing the camera from the internet.

1. Go to Network Setup Prots/Connections DDNS.

2. Enable, save and use DDNS to log in.

To get camera status, parameters and alarm information and remotely manage the camera, the SNMP function can be used. Before

using SNMP, please install an SNMP management tool and set the parameters of the SNMP, such as SNMP port, trap address.

1. Go to Network Setup Prots/ConnectionsSNMP.

Table of Contents