Home Position; Wiper Setup; Display Setup; Load Default - Speco O4P25X2 User Manual

Ptz network camera

Hide thumbs Also See for O4P25X2:

Table of Contents



Note: If the dome is on the menu state on an alarm, any command is negative.

4.4.7 Home Position

Go to System SetupHome Position menu as shown below:

The setting steps:

① Enable the home position function and select the preset which should be set in advance.

② Then select delay time (range from 007s to 180s) and exit the menu.

When the stand-by time of the dome camera exceeds the delay time, the camera will automatically execute the command to

monitor the selected preset.

Some models may not support this function. Go to Main MenuWiper Setup as shown below.

① Set the speed level and run time.

② Call "START" to enable wiper function.

You can enable title display and time display as needed.

There are three menus, including master reset, master clear and system reboot.

【Master Reset】 : Restore the camera state and active menu to the factory default settings but do not clear those parameters such as

preset, cruise.

【Master Clear】：Restore the camera to the factory default settings.

【System Reboot】：Reboot the camera.

Table of Contents