Alarm In (Sensor Input); Alarm Out - Speco O4P25X2 User Manual

Ptz network camera

Hide thumbs Also See for O4P25X2:

Table of Contents

5.4.3 Alarm In (Sensor Input)

This function is only available for some models. To set sensor alarm (alarm in):

Go to Event SetupAlarm In interface as shown below.

1. Click "Enable" and set the alarm type, alarm holding time and sensor name.

2. Set alarm trigger options. The setup steps are the same as motion detection. Please refer to

motion detection

chapter for details.

3. Click "Save" button to save the settings.

4. Set the schedule of the sensor alarm. The setup steps of the schedule are the same as the schedule recording setup. (See

Schedule

Recording).

This function is only available for some models. Go to AlarmAlarm Out.

Alarm Out Mode: Alarm linkage, manual operation, day/night switch linkage and schedule are optional.

Alarm Linkage: Having selected this mode, select alarm out name, alarm holding time at the "Alarm Holding Time" pull down list box

and alarm type.

Manual Operation: Having selected this mode, select alarm type and click "Open" to trigger the alarm out immediately; click "Close"

to stop alarm.

Table of Contents