Table of Contents
Advertisement
inoLab 740
Connecting the
external printer/PC
Printing/
transmitting data to the
Selecting the measured
variable to be recorded
ba75446e05
07/2010
12.3.5
Outputting data to an external printer or PC
In order to transmit data to an external printer or PC, follow the settings
in the RS232/Prt menu.
inoLab 740 allows an external printer to be run on the RS232/REC
interface.
Connect the external printer to the RS232/REC interface.
Printing or transmitting data to a PC is the same as for the integrated
printer (see chapter 12 D
PC
Note
In order to store the data in a file on the PC, a terminal program is
required that can continuously store the received data.
12.4
Outputting data to the external recorder
To record measured values graphically, you can also connect an
analog external recorder to the RS232/REC interface to the terminal.
Note
Before recording measured values with the external recorder, please
observe the following points:
Switch off AutoRange (automatic measuring range switch-over),
Set the measuring range manually
(tables with the possible measuring ranges can be found in chapter
15 T
ECHNICAL DATA
Switch the data output to the RS232/REC interface,
Select the measured variable to be recorded in the menu.
As soon as the data output is directed to the RS232/REC interface and
the measured variable to be recorded is selected, the corresponding
voltage is output on the RS232/REC interface.
1
Switch to the Menu mode.
2
Use
3
Use
4
Use
5
Select the measured variable to be recorded with
ATA OUTPUT
, section 15.1 T
46
to select the main Opt menu.
82
to select the Ana. Rec menu item.
g
to confirm the Ana. Rec menu item.
).
),
ERMINAL
82
Data output
.
199
Advertisement
Table of Contents
