Safety chapter
2.3 Personnel qualification
Task
Storage, transport, unpacking
Assembly
Planning the hydraulic installation
Hydraulic installation
Electrical installation
Start up
Operation
Maintenance, repair
Decommissioning, disposal
Troubleshooting
8
Only use the pump to meter liquid feed chemicals.
n
Pumps with the identity code option "Multi-layer safety diaphragm with
n
rupture signalling (contact)" are only approved for use with flammable
feed chemicals with electrically conductive dosing heads, at back
pressures of over 2 bar and only if the operator takes appropriate
safety measures.
Pumps with the identity code option "Multi-layer safety diaphragm with
rupture signalling (contact)" are only approved for use with hazardous
feed chemicals, at back pressures of over 2 bar and only if the oper‐
ator takes appropriate safety measures.
Pumps with the identity code option "Multi-layer safety diaphragm with
n
rupture signalling (contact)" are only approved for use with hazardous
feed chemicals, at back pressures of over 2 bar and only if the oper‐
ator takes appropriate safety measures.
Only "H - Hygienic head" design of pumps may be used for applica‐
n
tions in accordance with the hygiene requirements of closed pro‐
cesses and wet cleaning without dismantling.
Only use the pump once it has been correctly installed and started up
n
in accordance with the technical data and specifications contained in
the operating instructions.
Observe the general limitations with regard to viscosity limits, chem‐
n
ical resistance and density - see also the ProMinent Resistance List
(in the Product Catalogue or at www.prominent.com)!
All other uses or modifications are prohibited.
n
The pump is not designed to meter gaseous media and solids.
n
The pump is not intended for the metering of explosive substances
n
and mixtures.
The pump is not intended for unprotected use outdoors.
n
The pump is not intended for private use.
n
Only trained and authorised personnel should be allowed to operate
n
the pump - see the table below.
You have a duty to observe the information contained in the operating
n
instructions during the different phases of the service life of the unit.
You have a responsibility to observe the information contained in the
n
operating instructions for the auxiliary equipment at the different
phases of its respective service life.
ATEX designs only: Refer to the chapter "
n
mation for ATEX designs' on page 12 ".
Qualification
Instructed person
Technical personnel, Service
Qualified personnel with a thorough knowledge of oscillating displacement
pumps
Technical personnel, Service
Electrical technician
Technical personnel
Instructed person
Technical personnel, Service
Technical personnel, Service
Qualified person, electrical technician, instructed person, Service -
depending on the requirement
Ä Chapter 2.7 'Safety infor‐