Table of Contents
Advertisement
Power end and motor - ATEX
TTT - ATEX liquid end
SST - ATEX liquid end
Installation height
2.7.6 Safety equipment
Other safety equipment - ATEX labels
Requirements if the motor is being
installed independently
Assembly of the motor - with designs
without motor
Data
Ambient temperature during operation:
Data
Max. temperature, long-term at max. oper‐
ating pressure
Minimum temperature.
Data
Max. temperature, long-term at max. oper‐
ating pressure
Minimum temperature.
Data
Maximum installation height*:
* We urgently advise you to contact a specialist for ATEX motors with
higher installation heights!
WARNING!
–
The following safety information must be affixed to
pumps that include parts made of electrically non-
conducting plastic.
–
Ensure that the label is always fitted and legible.
–
Do not allow other labels to be stuck over this label.
W a r n i n g
e l ec t r o st a t i c d i sc h a r ge
- r e f e r t o op e r a t i n g i n s t ru c t i o n s
Fig. 2
The operator must be able to:
With ATEX motors: perform an ignition hazard assessment
n
WARNING!
The following instructions relevant in areas at risk from
explosion apply in areas at risk from explosion.
Safety chapter
Value Unit
-10 ... +40 °C
Value Unit
50 °C
-10 °C
Value Unit
90 °C
-10 °C
Value Unit
1000 m a.s.l.
D a ng e r fr o m
19
Advertisement
Table of Contents
