Maintenance - AJAX KeyPad S Plus Jeweler Manual

or one bar is displayed, move the keypad or use the
extender .
Use double-sided tape only for temporary installation. The device attached to the
tape may come unstuck from the surface anytime. As long as the device is taped,
the tamper will not be triggered when the device is detached from the surface.
2. Check the convenience of code entry using Tag or Pass to manage security
modes. If it is inconvenient to manage the security at the selected location,
relocate the keypad.
3. Remove the keypad from the SmartBracket mounting plate.
4. Attach the SmartBracket mounting plate to the surface using the bundled
screws. When attaching, use at least two xing points. Be sure to x the
perforated corner on the SmartBracket plate so the tamper responds to a
detachment attempt.
5. Tighten the holding screw on the bottom of the detector's enclosure for
more reliable fastening and protection from quick dismantling.
6. As soon as the keypad is xed on the SmartBracket, it shall blink once with
LED X — this is a signal that the tamper has been triggered. If the LED does
not blink after installation on SmartBracket, check the tamper status in the
Ajax app, and then make sure the plate is rmly attached.

Maintenance

radio signal range