AJAX KeyPad S Plus Jeweler Manual page 4

KeyPad S Plus arms and disarms the security of the entire facility or separate
groups and allows activating the Night Mode. You can control the security
modes with KeyPad S Plus using the following:
1. Codes. The keypad supports general and personal codes and arming
without entering a code.
2. Cards or key fobs. You can connect
system.
KeyPad S Plus supports the following code types:
Keypad code — general code set up for the keypad. When used, all events
are delivered to Ajax apps on behalf of the keypad.
User code — personal code set up for a user connected to the hub. When
used, all events are delivered to Ajax apps on behalf of the user.
Keypad access code — a code set up for a person who is not registered in
the system. When used, events are delivered to Ajax apps with a name
associated with this code.
The number of personal codes and access codes depends on the hub model.
Before entering a code or using Tag/Pass, you should activate ("wake up")
KeyPad S Plus by sliding a hand over the touch panel from top to bottom. The
button backlight is enabled when activated, and the keypad beeps.
KeyPad S Plus has LED indicators showing the current security mode and
keypad malfunctions (if any). The security status is displayed only when the
keypad is active (the device backlight is on).
Tag key fobs and Pass cards to the