Outputs; Timers - Deif SGC 421 User Manual

3.5.4 Outputs

Outputs # (OUT #)
Parameter
Source
(SOURCE)
On Activation
(ON ACTIVATION)
3.5.5

Timers

Cranking (CRANKING TIMERS)
Parameter
Crank Hold Time
(CRANK HOLD TIME)
Crank Rest Time
(CRANK REST TIME)
Manual Start Delay
(MANUAL START
DELAY)
Auto Start Delay
(AUTO START DELAY)
Start/Stop (START/STOP TIMER)
Parameter
Safety Monitoring
Delay
(SAFETY MONITOR
DELAY)
Warm-Up Delay
(WARM-UP DELAY)
Return To Mains Delay
(RETN-TO-MAINS
DELAY)
Engine Cooling Time
(ENG COOL TIME)
Stop Action Time
(STOP ACTION TIME)
Additional Stopping
Time
(ADDN STOPPING
TIME)
Load Transfer Delay
(LOAD TRANSFER
DELAY)
User manual 4189341355A EN
Range
See Digital output
source selection in
this document
Energise
De-energise
Range
1 to 255 s
2 to 60 s
0 to 300 s
0 to 43200 s
Range
10 to 60 s
0 to 60 s
0 to 600 s
0 to 300 s
10 to 120 s
0 to 120 s
1 to 60 s
Default
-
De-energise
Default
5 s
5 s
3 s
3 s
Default
10 s
3 s
5 s
5 s
30 s
10 s
1 s
Description
Select an output source from the list.
Select what the status of the output source is
when it is active. You can select if it is
energised or de-energised.
Description
Configure for how long the engine cranks.
The time between each crank.
When this timer expires in manual mode, the
engine starts to crank.
When this timer expires in AUTO mode, the
engine starts to crank.
Description
The engine safety parameters are not
monitored during the Safety monitoring delay.
The timer starts after crank disconnect.
When the alternator voltage and frequency are
OK, the load is transferred to the alternator.
There's a warm-up delay before the load is
transferred.
The controller closes the mains breaker when
the return to mains delay timer expires.
When the engine cooling timer expires, the
engine stops.
The time duration for the stop action sequence.
Additional time added to the engine stop
sequence.
The time it takes to transfer the load to the
mains or genset.
Page 34 of 92