Table of Contents
Advertisement
8. CAN bus engine communication
8.1
Overview
8.1.1
About
Engine communication allows the SGC controller communicate with different engine types over CAN bus. Some engine
types only allow the SGC to read information from the ECU. Other engine types allow the controller to regulate and transmit
commands to the ECU.
NOTE
See the ECU user manuals for the ECU protocol technical description and details of each communication value.
Other engines and controllers
For engines and controllers not listed in this document, contact DEIF.
8.1.2
Default settings
The SGC controller is delivered with a set of default settings for engine communication. These settings are not necessarily
correct for your engine or genset. Check all the settings before you operate the engine or genset.
8.1.3
Supported engines
The SGC controller can communicate with these engines:
Manufacturer
Cummins
Cummins 500
Cummins 558
Cummins 570
Cummins 850
Cummins 2150
Cummins 2250
DCEC Cummins
Deutz - EMR
Generic J1939
Hatz
Iveco
KUBOTA
MTU
Perkins ADEM4
Scania
Volvo Penta
Weichai
Yuchai BOSCH
Yuchai YCHCU ECU
User manual 4189341355A EN
SGC can write commands
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Page 81 of 92
Advertisement
Table of Contents
