Transmitting Data (Usb Interface); Options For Data Transmission - wtw pH 3310 Manual

Operation
52
4.6

Transmitting data (USB interface)

4.6.1 Options for data transmission

Via the USB interface you can transmit data to a PC. The following
table shows which data are transmitted to the interface in which way:
Data
Current
measured values
of all connected
sensors
Stored measured
values
Calibration
records
Note
The following rule applies: With the exception of the menus, shortly
pressing the <F2>/[USB output] key generally outputs the display con-
tents to the interface (displayed measured values, measurement data-
sets, calibration records).
Control Operation / description
 With <F2>/[USB output].
Manual
 Simultaneously with every
 With <F2
Automatic, at
intervals
 Simultaneously with every
 Displayed dataset with
Manual
 All datasets with the Output
For details, see section 4.5.3.
 Calibration record with
Manual
For details, see section 4.6.
 At the end of a calibration
Automatic
manual storage process
(see section 4.5.1).
_
>/[USB output].
Then you can set the trans-
mission interval.
Note:
For operation with MultiLab
pilot: set the Send ID option
to No (see section 4.7).
automatic storage process
(see section 4.5.2).
<F2>/[USB output] after
calling up from the memory.
to USB function.
<F2>/[USB output].
procedure.
ba75802d06
pH 3310
05/2017