Table of Contents
Advertisement
3.4. Setting the acceleration table Paper Guides
The patented 'floating' or tilting delivery table on the colorSplash EPP
envelope feeder is designed to advance the envelopes that the feed belts
deliver, one at a time, into the printer's manual feed tray feed roller.
The acceleration table is equipped with self centering paper
guides, an envelope drive belt and a stop photo sensor at the
end. The photo sensor is used to stop each envelope in position
underneath the printer's feed roller, for take-away by the printer.
An additional photo sensor is positioned a few inches back
from the stop sensor. This is the restart sensor. When the first
envelope is pulled away by the printer, the trail edge of that
envelope uncovers the start sensor, which starts the feeder
motor. Using the dual sensors allows the colorSpalsh EPP
envelope feeder to run larger envelopes at higher speeds.
1
Step 2. Grasp the acceleration table paper guide block and
slide the paper guides inward until they are close to
the edges of your envelope.
Paper guide locking knob
Do not set the guides tightly against
the envelope. Too tight will restrict the
envelope movement.
Note: The acceleration table paper guides can be locked in to position by tightening the paper guide block
locking knobs.
Step 1. After the feeder portion of the machine has been
After setting these guides, remove the envelope.
set for your envelopes as per the previous section,
position one of your envelopes over the exit end of
the acceleration table between the paper guides.
Lift hold down strap to place envelope
underneath
2
19
Advertisement
Table of Contents
