Table of Contents
Advertisement
Step 4. With one hand, raise the back end of the
envelope stack up and then slide the back
wedge into position underneath the back
end of the stack. Lock the wedge in place
with the locking knob.
Step 5. The angle of the back wedge can be adjusted to
assist with different kinds of envelopes. To adjust
the angle, loosen the locking lever on the side of
the back wedge.
Back wedge upright
Locking lever
6
4
as shown in the pictures above and left, the back wedge
should be in just far enough to hold the back edge of the
envelope stack up off the belts.
5
Step 6. The height of the back wedge ramp can also be
adjusted by loosening the round locking knob on
the back of the upright as shown here. For smaller
envelopes, the top of the ramp should be slightly
below the top of the upright.
17
Advertisement
Table of Contents
