Table of Contents
Advertisement
5.6. Setting the Intec ColorSplash Envelope Feeder's Speed Control
Testing of various sized envelopes has resulted in the following suggestions for speed settings :
EU – DL envelopes / US - #10 envelopes, (landscape orientation) - 50% to 60 % speed
EU – C5 envelopes / US - 6 x 9 envelopes (landscape) - 50% to 75% speed
EU – C4 envelopes / US - 9 x 12 or 10 x 13 envelopes (either orientation) 80% to 100% speed.
These speed settings are just recommendations. Some experimenting will be very helpful. Envelope types, orientation
and feeder setup and condition are all factors that can affect operation.
clean the white feed belts regularly with isopropyl alcohol to ensure best results.
5.7. removing the feeder from the printer
Step 1. With your right hand, press the latch release
lever on the rear side of the cabinet downward
and hold in this position.
2
After you have moved the feeder 75–150mm (several inches) away from the printer you can release the latch lever.
NOTE: Be careful as the acceleration table clears the manual feed tray and ensure to lower it
carefully. Do not let it drop freely.
1
Step 2. With your left hand, lift the acceleration table while
you pull the feeder away from the printer.
26
Advertisement
Table of Contents
