Table of Contents
Advertisement
2.2.3. Fitting the Paper hold down Strap
Step 11. Remove the shoulder screw from the paper hold down strap pivot block.
Pivot block for paper
hold down strap
Shoulder screw
Step 12. Place the end of the hold down strap (opposite pivot
block end) underneath the acceleration table cross bar
and on top of the transport belt.
13
Step 14. Attach the pivot block to the mounting block on the
bridge using the 1/8" Allen wrench to tighten securely.
Strap weights
Step 13. Position the hold down strap pivot block next to the
mounting block (on the right side) on the bridge and
insert the shoulder screw into the pivot block.
The hold down strap assembly should
pivot at the shoulder screw and should lie
flat on the transport belt.
The steel weights on the strap apply downward
pressure on the envelopes to ensure consistent
movement of the envelopes by the transport belt.
9
12
14
Advertisement
Table of Contents
