Step 5. continue to slowly lower the separator tip until the envelope is buckled downward between the
belts slightly (approx 2mm (1/16") to 3mm (1/8").
NOTE: Ensure that the separator tip is between feed belts so it does not 'pinch' the envelope.
Step 6. (optional) If you are using two separators, repeat the above steps for both.
NOTES: The separators do not need a lot of fine tuning, as a small buckle is all that is required.
Some experimentation is recommended to get the best results with your materials.
One or both separators can be used as desired, but be sure to position the separators between belts and buckle the
envelopes down slightly.
There is no specific configuration that you must use as this design offers tremendous flexibility. If one setup doesn't
work, try moving the separators to different positions across the feeder bridge.
5
Lower the separator tip to 'buckle' the envelope down between belts
15