Removing The Outer Separation Pad; Installing Non-Reflective Aid For Envelope Feeders Optical Sensors - Intec ColorSplash CS4000 Installation And Setup Manual

2.1.2. removing the outer Separation Pad

Step 5. Open the right side cover on the printer by
pulling on the latch shown here:
6
Step 7. Pinch the two upper corners of the
notE: The envelope feeder is equipped with paper sensors positioned just to the left of
the printer's manual feed tray feed roller and in the centre of the floating delivery table. It is
possible for the sensors to detect the white plastic housing just to the left of the feed roller,
and reflective silver housing above the middle sensor, which can cause erratic feeding.
It is very important to place the black tape or Velcro™ (included with feeder) in these 2 positions.
Note: This tape will not affect the printer and can be left in place, even when not using envelope feeder
sheet separator assembly (rubber
pad) and remove the assembly from
the printer.
Remove the separator assembly
5
Step 6. With the right side door fully open,
lift the feed roller assembly to gain
access to the feed roller and sheet
separator area.
7
Place black
tape
in these areas
6