Table of Contents
Advertisement
4. ChECkInG yoUr FEEdEr SEtUP
Step 1. Pull the first envelope out of the end of the
acceleration table. The feeder should advance
the next envelope into position over the stop photo
sensor. Repeat this procedure to ensure that the
feeder is functioning properly.
If there is no gap, you may need to move your back wedge in underneath the envelope stack a little more or
lower the separator tip a bit to create a more pronounced buckle for better envelope separation.
If the envelopes do not feed consistently or the gap between envelopes on the delivery
table exceeds 3 or 4 inches, you may need to move the back wedge back a little to let
the envelopes contact the feed belts more.
If you are satisfied with the consistency of the envelope feeding and the envelopes are advancing forward on
the acceleration table smoothly without restriction or skew, your feeder is now ready to move into position
with the printer.
Move the green 'ready/feed' switch to the 'stop feeding' position and remove the lead envelope from the
end of the acceleration table.
1
As you pull each envelope out of the exit end of the
acceleration table, make note of the gaps between the
envelopes as they travel down the delivery table. A small
gap of 25mm – 75mm (1" to 3") is satisfactory although
the gap can vary a bit.
21
Advertisement
Table of Contents
