Envelope Feeder's Latch Mechanism - Intec ColorSplash CS4000 Installation And Setup Manual

7

5. 2. Envelope Feeder's latch Mechanism

Step 8. Push the feeder in completely until it is stopped.
You should hear a 'positive' clunk as the latch
mechanism engages. The front edge of the cabinet
will be against the side of the printer below the
manual feed tray.
When the feeder is pushed all the way in these latches will connect to the printer automatically
and you will hear a satisfying 'clunk' as they engage.
Step 7. When the end of the acceleration table is 25-50mm
The latch mechanism mentioned above, Latches on the
feeder cabinet under the acceleration table. The latch
mechanism is designed to hold the feeder in position against
the printer. The picture on the left shows these latches with
the feeder removed.
To pull the feeder away from the printer, press
down on the release lever on the rear of the
feeder cabinet to lift the latches.
23
(several inches) into the manual feed tray, let the
acceleration table down to rest on the manual feed
tray. continue to push the feeder in towards the
printer ensuring that the ends of the dark gray side
plates enter the manual feed tray opening.
8
Pressing down on this lever
raises the latches to release
the feeder from the printer