Table of Contents
Advertisement
2.2.1. assembly of top Plate
Step 4. Using the included 1/8" Allen wrench, remove
the four button head screws from the top of
the back plate of the feeder.
5
2.2.2. assembly of the Feeder Bridge
7
Step 8. carefully position the bridge between the
side plates of the feeder and line up the
attaching holes.
9
4
Step 5. Attach the top plate to the feeder
using the four button head screws
removed in Step 4.
Be careful on steps 4 & 5 not to drop
the screws into the feeder.
Step 6. Tighten the screws holding the top
plate securely.
Step 7. Using the 1/8" Allen wrench, remove the two flat
head screws from each end of the bridge.
8
Step 9. Attach the bridge to the feeder using
the four flat head screws removed
from the bridge in Step 7.
Do not tighten any of the screws until
all four are in place.
Step 10. Tighten all four bridge screws.
8
Advertisement
Table of Contents
