Table of Contents
Advertisement
3. oPEratInG GUIdE
IMPortant: It is recommended that you set up the feeder for your envelopes before moving
the feeder into position with the printer. This will ensure complete access to the paper guides
on the acceleration table and make testing the feeder easy.
The colorSplash's EPP Envelope Feeder can feed a variety of envelope sizes and types into the printer via the printer's
manual feed tray. The following instructions illustrate the proper setup of the feeder.
Note: The feeder can be setup for your envelopes away from the printer and then easily placed in line with the printer
after setup is complete.
Setting up the Feeder for Envelopes
Setting the feeder for your envelopes consists of the following basic steps:
1. Setting up the hopper paper guides
2. Setting up the sheet separator(s)
3. Setting the back wedge (envelope stack support)
4. Setting the delivery table paper guides
5. Testing the feeder
6. Moving the feeder into position alongside the printer
3.1. Setting the hopper Paper Guides
Step 1. Ensure that the main power switch on the feeder's
control panel is in the OFF position and plug the 24
Vdc power supply, included with the feeder, in the
power jack on the control panel.
2
24 VDC power input
Step 2. Rotate the paper guide adjusting knob on the bridge
to position the paper guides outward toward the side
plates of your feeder.
11
1
Advertisement
Table of Contents
