Table of Contents
Advertisement
5.3. Setting the Feeder's speed control
Step 9. Set the speed control on the feeder to
approximately 50 to 60% of maximum if you
are running standard size envelopes. For larger
envelopes, set the speed control to approximately
80 to 100%.
5.4. resume Feeding switch /Paper out sensor control
10
Step 11. Push the 'FEEdER REAdY LEVER' on the operator
side of the acceleration table forward toward the
printer. This will trigger the manual feed tray paper
present sensor so the printer knows you have
envelopes in place.
FEEDER READY LEVER
Push this lever forward to begin
printing after advancing envelopes
When the feeder ready lever is pushed forward (left), the printer will recognize this as a signal that envelopes are
in place in the manual feed tray. do not push this lever forward until you have envelopes in the feeder and the first
envelope has been advanced to the exit end of the acceleration table.
When the lever is pushed forward, the manual feed tray will rise, lifting the acceleration table up to the printer's
feed roller (along with the envelope).
Step 10. With the red power switch on, move the green feed
switch to the 'resume feeding' position to start the
feeder motor. The lead envelope should advance
into the printer's manual feed tray until the stop
sensor signals the feeder motor to stop.
11
At this point, you are now ready to send data to the printer. If the
printer's Lcd display shows this screen, the feeder ready lever is
not forward in the ready position.
24
9
Advertisement
Table of Contents
