Taylor 0738 Operator's Manual page 32

OPERATING PROCEDURES
Freezer Door Assembly
1. Place the door O-ring into the groove on the
back of the freezer door.
6
2. Slide the two O-rings into the grooves on the
draw valve and lubricate them.
3. Lightly lubricate the inside of the top of the
freezer door valve cavity.
6-2
4. Insert the draw valve from the top, with the
flat part facing toward the machine.
Note: If the draw valve is inserted with the
flat surface facing the user, this will prevent
the machine from operating.
5. Insert the counter-beater on the rear pin on
the freezer door and rotate it until the pins
align with the holes in the door. Place the
counter-beater O-ring into the groove on
rear pin of the freezer door.
Model 0738 Operating Procedures