Section 3: Safety; Installer Information; To Operate Safely - Taylor 0738 Operator's Manual

Section 3

Installer Information

We at the Taylor Company are concerned about
the safety of the operator when he or she comes
into contact with the freezer and its parts. Taylor
has gone to extreme efforts to design and
manufacture built-in safety features to protect both
you and the service technician. As an example,
warning labels have been attached to the machine
to point out safety precautions to the operator.
DANGER! Failure to adhere to the
following safety precautions may result
in severe personal injury or death.
Failure to comply with these warnings may also
damage the machine and/or its components. Such
damage may require component replacement and
service repair expenses.

To Operate Safely

NOTICE! DO NOT operate the machine
without reading the Operator Manual.
Failure to follow this instruction may
result in machine damage, poor machine
performance, health hazards, or personal injury.
WARNING! Avoid injury.
•
DO NOT allow untrained personnel to
operate this machine.
•
DO NOT put objects or fingers in
the door spout.
•
DO NOT operate the machine unless all
service panels and access doors are
restrained with screws.
•
DO NOT remove the machine door or
beater assembly unless the main power
switch is in the OFF position.
Failure to follow these instructions may result in
severe personal injury from hazardous moving
parts.
Safety
WARNING! This machine has
many sharp edges that can cause
severe injuries.
•
DO NOT put objects or fingers in
the door spout. Failure to follow this
instruction may result in
contaminated product or personal
injury from blade contact.
•
USE EXTREME CAUTION when
removing the beater assembly. The
scraper blades are very sharp and
may cause injury.
IMPORTANT! Access to the service
area of the machine is restricted to
persons having knowledge and
practical experience with the machine, in
particular as far as safety and hygiene are
concerned.
CAUTION! This machine must be
installed on a level surface to avoid the
hazard of tipping. Extreme care should
be taken in moving this machine for any reason.
Two or more persons are required to safely move
this machine. Failure to comply may result in
personal injury or machine damage.
WARNING! Avoid injury.
•
DO NOT operate the machine unless it is
properly grounded.
•
DO NOT operate machine with larger
fuses than specified on the data label.
•
All repairs must be performed by an
authorized Taylor service technician.
•
The main power supplies to machine must
be disconnected prior to performing
repairs.
•
For Cord-Connected Machines: Only
authorized Taylor service technicians or
licensed electricians may install a plug or
replacement cord on the machine.
Model 0738
Safety
3
3-1