Table of Contents
Advertisement
AND NET/GROSS KEY, NET/GROSS KEY, PRINT KEY
This combination will print the Gross accumulator.
AND NET/GROSS KEY, NET/GROSS KEY, ZERO KEY
This combination will zero (clear) the Gross accumulator.
AND UNITS KEY
This combination will enter the Test mode. The Test mode is used to test of all the
display elements. It consists of five (5) cycles, each lasting about one (1) second:
1. All horizontal segments will turn on (no annunciators).
2. All vertical segments and decimal points will turn on (no annunciators).
3. All annunciators will turn on.
4. All display elements off.
5. The model number (210FE) and the software version X.X.
6. The calibration numbers (C1 to C4).
AND PRINT KEY
This combination is used to change the selected print ticket format. Pressing the
key then the PRINT key will display a prompt "Prt=". Press the ENTER key to show
the current value. If the setting displayed is acceptable, press the ENTER key again
to save it. Otherwise, using the numeric keys enter the new setting, then press the
ENTER key to save it. Allowable values are:
0 = print tab settings
In addition to using the key, PRINT key combination to change the print ticket
format, the operator (just prior to printing the ticket) can change the print ticket format
at the end of the weighing operation. This is accomplished by performing the normal
weighing operation, then pressing the desired format number (0, 1 or 2), followed by
pressing the PRINT key.
NOTE: When a print format is selected (by either method), it will remain active until
changed by the operator.
The 210FE indicator has an extra-bright 2 1/2" LED weight display. Ten levels of brightness
can be set from the 210FE keypad by using a combination of the key and the 1 or 0 key.
To Increase Brightness:
1. Press the key and then the 1 key.
2. Repeat pressing the 1 key to increase the brightness to the desired level.
3. When the brightness is at the desired level, press the ENTER key to save the setting
and return to normal operating mode.
To Reduce Brightness:
1. Press the key and then the 0 key.
2. Repeat pressing the 0 key until the brightness has been reduced to the desired
level.
3. When the brightness is at the desired level, press the ENTER key to save the setting
and return to normal operating mode.
8200-0727-2M Rev A 210FE Installation & Technical
28
KEYPAD FUNCTIONS, CONT.
1 = visual ticket format 1
DISPLAY BRIGHTNESS
2 = visual ticket format 2
Advertisement
Table of Contents
