Display Scale Wi-Fi And Bluetooth Settings - Cardinal Detecto 750C Setup And Operation Manual

DISPLAY WI-FI AND BLUETOOTH SETTINGS
The 750C Clinical Weight Indicator allows you to easily view the Wi-Fi and Bluetooth Settings
without having to perform a calibration switch setup. To display the Wi-Fi and Bluetooth
Settings, follow the steps below:
1. With no weight on the scale, press and hold the
display shows the prompt
2. With the display showing
revision, and then press the
3. If Wi-Fi is enabled
a. With the display showing
Disconnected (
next setting.
b. The next four prompts will be
IP address. Press the
After viewing the setting for
c. The next prompt will be
setting, and then press the
4. The next prompt will be
key. The Bluetooth (BLE) advertisement data 750 Scale XX:XX:XX:XX:XX:XX will scroll
across the display. Note that the X's represents the MAC address and that the colons
between the MAC address will not be shown.
NOTE: The factory setting for Bluetooth (BLE) is On,
(BLE) has been turned Off,
will not be displayed.
5. When the display stops scrolling, press the
showing live weight.
6. The indicator is now ready for normal operation.
1
If the Wi-Fi is Disconnected (
"REDBIRD_WIFI_XX:XX" AP, then the Wi-Fi module is in listening mode. Refer to the
Configure Wi-Fi Network Module section for the procedure to set the Wi-Fi credentials.
8555-0547-0M Rev B 750C Wi-Fi and Bluetooth Manual
.
press the key to view the Redbird software
key to view the next setting.
= , the following settings will be shown:
, press the
or ) will be displayed. Press the
, ,
key to view the setting of each octet of the IP address.
, press the
, the network name. Press the
key to view to the next setting.
, the Bluetooth (BLE) advertisement data. Press the
= (0 = off), the Bluetooth (BLE) advertisement setting
key. The display will change back to
), and a scan of the Wi-Fi networks shows
key for about 5 seconds until the
key. The Wi-Fi status Connected or
key to view the
, and , the four octets
key to view the next setting.
key to view the
= (1 = On). If Bluetooth
1
of the
13