Table of Contents
Advertisement
ANNUNCIATOR DISPLAY, CONT.
NOTE! The C Z, M O, P C or T L is alternately displayed or replaces the weight units,
when appropriate, in the upper two characters.
C Z
This indicates that the weight displayed is within +/- 1/4 division of the Center of Zero. It is
displayed in the two upper characters of the annunciator display.
M O
This indicates that the change in successive weight samples is greater than the Motion limits
selected during setup. It is displayed in the two upper characters of the annunciator display.
P C
This is used to indicate that the display is in the Count mode and the value displayed is the
count quantity and not weight. It is displayed in the two upper characters of the annunciator
display.
T L
This is used to indicate that the display is in the Count mode and that the value displayed is
the current contents (total) of the count accumulator. It is displayed in the two upper
characters of the annunciator display.
G
This is turned on to show that Gross weight is displayed. Gross weight will be displayed when
no tare weight is stored. It is displayed in the lower character of the annunciator display.
N
This is turned on to show that the displayed weight is the Net weight (gross weight less tare
weight). It is displayed in the lower character of the annunciator display.
T
This is turned on to show that the displayed weight is the Tare weight. It is displayed in the
lower character of the annunciator display.
8200-0727-2M Rev A 210FE Installation & Technical
30
Advertisement
Table of Contents
