Table of Contents
Advertisement
Before beginning installation of your 210FE Weight Indicating Instrument, make certain that the
instrument has been received in good condition. Carefully remove the instrument from the
shipping carton and inspect it for any evidence of damage (such as exterior dents or
scratches) that may have taken place during shipment. Keep the carton and packing material
for return shipment if it should become necessary. It is the responsibility of the purchaser to file
all claims for any damages or loss incurred during transit.
Mounting
The Model 210FE indicator is housed in a Stainless Steel wall or desk-mount enclosure. The
gimbal may be mounted on a desktop or other smooth, flat, horizontal surface or may be
mounted on a wall. Refer to Figure No. 1 for a layout of wall-mounting bolts.
If wall mounted, make certain the mounting surface is strong enough to support the indicator.
The mounting location should be where the display is easily viewed while being close enough
to provide the operator easy access to the keypad. Carefully lay out the mounting hole
locations, then drill and install the anchor bolts. Attach the gimbal to the wall and securely
tighten the retaining bolts.
100 to 240 VAC
(50/60 Hz) @
0.4A
8200-0727-2M Rev A 210FE Installation & Technical
INSTALLATION
10.00"
Figure No. 1
Load Cells
Figure No. 2
Clearance for
#10 size screw
Calibration
Switch
Access
Screw
7
Advertisement
Table of Contents
