Installation; Mounting The 825 - Cardinal 825 Installation And Technical Manual

Before beginning installation of your Model 825 Weight Indicator, make certain that it has been
received in good condition. Carefully remove it from the shipping carton and inspect it for any
evidence of damage (such as exterior dents or scratches) that may have taken place during
shipment. Keep the carton and packing material for return shipment if it should become
necessary. It is the responsibility of the purchaser to file all claims for any damages or loss
incurred during transit.

Mounting the 825

NOTE: If your 825 indicator is already installed on a scale, the following information
describing its installation does not apply.
The Model 825 Indicator is housed in a stainless steel wall or desk-mount enclosure. The 825
gimbal may be mounted on a desk, table or other smooth, flat, horizontal surface or may be
mounted on a wall. Refer to Figure No. 1 for a layout of wall mounting.
If wall mounted, make certain the mounting surface is strong enough to support the instrument.
The mounting location should be where the display is easily viewed while being close enough
to provide the operator easy access to the keypad. Carefully lay out the mounting hole
locations, then drill and install the anchor bolts. Attach the gimbal to the wall and securely
tighten the retaining bolts.
10

INSTALLATION

8545-M838-O1 Rev D  825 Installation & Technical
Figure No. 1
Clearance for
#10 size screw