Table of Contents
Advertisement
SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
2.3.1 Walk-Around Inspection
Begin the "Walk-Around Inspection" at Item 1, as noted
on the diagram. Continue checking each item in
sequence for the conditions listed in the following
checklist.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS OFF.
DO NOT OPERATE MACHINE UNTIL ALL MALFUNCTIONS HAVE
BEEN CORRECTED.
INSPECTION NOTE : On all components, make sure
there are no loose or missing parts, that they are
securely fastened, and no visible damage, leaks or
excessive wear exists in addition to any other criteria
mentioned.
1. Platform Guardrails and Gate - Footswitch works
properly, not modified, disabled or blocked. The
gate opens and closes properly.
2. Platform & Ground Control Consoles - Switches
and levers return to neutral, decals/placards
secure and legible, control markings legible.
2-4
Figure 2-1. Daily Walk-Around Inspection
– JLG Lift –
3. Wheel/Tire Assemblies - Properly secured, no
missing lug nuts.
4. Drive Motor, Brake - No evidence of leakage.
5. Hood Assemblies - See Inspection Note.
6. Hand Pump - See Inspection Note.
7. All Hydraulic Cylinders - No visible damage;
pivot pins and hydraulic hoses undamaged, not
leaking.
8. Steering Spindles - See Inspection Note.
9. Lifting Chains, Chain Yokes and Clevis Pins -
Must be installed and in good condition. Chains
must be correctly tensioned and lubricated.
31210005
Advertisement
Table of Contents
