Emb-Mp Charger - JLG TOUCAN 1010I Operation And Safety Manual

EMB-MP Charger

- Display panel :
• a : Charge indicator (green)
• b : Final charge indicator (yellow)
• c : Battery indicator charge completed (green)
• d : Fault indicator (red)
• e : Circuit-breaker
- Charging the battery :
- Connect the charger plug to the power supply.
- Once the charger is connected, all the LEDs begin to
flash for a short period of time, indicating the charger
is completing a self-test.
- The LEDs (c) and (d) will then flash for a short period
of time, indicating the charger is in «automatic
starting» mode.
- The charging phase starts, the green LED (a) flashes
slowly (Frequency = 1 Hz) during the duration of the
charge.
- Once the final charging phase has been reached
(approximately 80%), LED (a) still flashes and LED
(b) lights up fixed.
- At the end of the charging process, both LEDs (a) and
(c) are on fixed.
- Equalization charge :
- When the charger is doing an equalization charge :
• both LEDs (a) and (c) flash slowly.
• LED (b) is lit fixed.
- Fault indicator :
- Should the transformer overheat, the red LED (d)
flashes quickly (F=5 Hz).
- If the battery does not reach 2.4V/cell after a 10 hours
charge, the charging process stops and the red LED
(d) lights up.
- It is advised to have either the charger or the battery
checked by a technician.
31210005
SECTION 4 - MACHINE OPERATION
- LEDs signal :
OFF = the LED is off
ON = the LED is lit fixed
BL = the LED flashes (F=1 Hz)
BV = the LED flashes quickly (F=5 Hz)
(*) = the LED can be on or off, depending on the state
of charge of the battery and on the charger's operation
at that moment.
– JLG Lift – 4-7