Table of Contents
Advertisement
Installing the New Moisture Generator
1. Install the new Moisture Generator on the mounting bracket in the correct
2. Carefully reconnect the 1/16-inch fittings (two on the generator and one
3. Place the sample manifold plate back in the Oven and secure with the four
4. Reconnect all four (4) 1/16 fittings on the bracket in the center of the Oven.
5. Replace the Sample Oven Cover, and secure it with the two (2) nuts (Figure
6. Replace the Analyzer Cover and secure it with the mounting screws.
7. Power up the analyzer. Wait until the boot-up sequence is complete. Enter
Solenoid Valves
1. Remove the Analyzer Cover from the analyzer.
2. Remove the Sample Oven Cover.
3. Disconnect the 1/16-inch fittings on all four (4) sample tubes, which are
4. Remove the four (4) nuts that secure the sample manifold plate (the square
5. If you are replacing any of the three-way solenoid valves, disconnect the
4-12 | 3050-RM Moisture Analyzer
orientation (Figure 4-6) and remount the bracket on the sample manifold
plate.
(1) on the pressure transducer).
(4) mounting nuts.
4-1).
the new Moisture Generator production code in the software (refer to
Chapter 2 for details).
located on the bracket in the center of the Sample Oven (Figures 5-4 and
4-7.1).
aluminum mounting plate, located in the front section of the Oven), and
gently lift the manifold out of the Oven (Figure 4-5).
All of the wiring connections should still be intact at this time; you
will need to rest the sample manifold plate on top of the analyzer to
perform the valve replacement.
1/16-inch fitting that connects the top port on the valve to the Exhaust
Manifold (Figures 4-7.1 and 4-7.2).
If you are removing the 3-way solenoid that is directly behind the fan,
you will need to remove the fan first (Figure 4-7.1) so that you can ac-
cess the screws that hold the solenoid in place.
PN 305892901, Rev S
Advertisement
Table of Contents
