Step 3: Mounting The Magnetic System; Check Air Gap X; Figure 10: Mounting The Magnetic System - KEB COMBISTOP 38 Instructions For Use Manual

Hide thumbs Also See for COMBISTOP 38:

Table of Contents

MOUNT brAKE

4.2.3 Step 3: Mounting the magnetic system

► Slide the fully assembled magnetic system over the hub and the lining.

► While doing so, make sure that the lining is easily movable

► Fix the magnet system with three socket head screws without defined torque.

► Apply rated voltage. Thus the armature is pulled towards the housing in the oppo-

► Tighten the screws to the defined tightening torque. Observe the notes to the sock-

Legend

Figure 10:

Further information on the air gap which becomes larger as a result of wear can be

found in section =>

site direction to the spring forces.

et head screws!

Motor shaft

Magnet system

Mounting the magnetic system

Notes to the socket head screws

For fastening the magnetic system, we recommend socket head screws of

strength class 8.8, which should be tightened with the tightening torques rec-

ommended by the manufacturer.

„9.2.2 Check air

①

gap".

②

Table of Contents