Parameter Description | 5; Os Group: Operator System; Fb Group: Fieldbus Parameters; Fb00 Protocol Selector - KEB COMBIVERT G6 Instructions For Use Manual

5 Parameter description
5.1 OS group: Operator system
5.2 Fb group: Fieldbus parameters
5.2.1 Fb00 Protocol selector
5.2.2 Fb01 DIN66019II input select.
5.2.3 Fb02 Current protocol
5.2.4 Fb03 MODBUS node ID
5.2.5 Fb04 MODBUS baud rate
5.2.6 Fb10 MODBUS config
ma_dr_g6-modbus-20332669_en
The settings in this group correspond to the G6 standard version. Please refer to the G6
standard documentation for a further description.
These parameters set the fieldbus interface.
This group is available on the display and via a PC connection.
Selector to set the requested protocol:
• 0: DIN66019II
• 1: Modbus
• 2: DIN66019II is selected by input activation. Input is selectable on parameter Fb01.
Lower limit Upper limit
0 2
Input selection to activate/deactivate DIN66019II instead of MODBUS.
If the function is set to "0 = off", the DIN66019II cannot be selected by input.
Lower limit Upper limit
0: off 7: RST
Specifies the current protocol for the D-Sub DE-9 port.
0: DIN66019II
1: MODBUS
Lower limit Upper limit
0 1
Slave address for MODBUS protocol only.
Lower limit Upper limit
0 239
D-Sub DE9 transmission speed. Value is reset to default if parameter os15 (Store diag.
baudrate) is not set to 'On'.
Lower limit Upper limit
0: 1.2 8: 100.0
Configures the MODBUS interface protocol.

Parameter description | 5

Standard value Unit
0 -
Standard value Unit
1: I1 -
Standard value Unit
0 -
Standard value Unit
1 -
Standard value Unit
5: 38.4 kBaud
11