Readjust Air Gap - KEB COMBISTOP 38 Instructions For Use Manual

MAINTENANcE AND SErvIcE

9.2.3 readjust air gap

NOTICE
As a result of wear, the nominal air gap increases. In order to ensure a trouble-free func-
tion, the air gap should be readjusted after reaching the air gap "X
NOTICE
This procedure can be repeated until the lining has reached its minimum permissible
thickness g
reworked.
Wrong air gap!
Damage of the brake!
► Check data sheet whether the air gap can be adjusted.
► Depending on the design, adjusting spacers can be fixed and im-
movable.
Uncontrollable rotational movements due to load effect!
► Switching the brake without load.
► Loosen socket head screws.
► Adjust the air gap by turning the adjusting spacers. Make sure that
the adjustment is evenly at all points.
► Tighten the socket head screws again.
► Check the air gap again and repeat the procedure if necessary.
. Then the friction lining and the friction surfaces must be replaced or
_min
" (T1).
Limit
47