Table of Contents
Advertisement
Installation
5.2 Mounting Surface Requirements
The eccentricity of the mounting bolt circle and angular deviation of the mounting surface
relative to the shaft end must not exceed the following values:
Size
Eccentricity (mm)
Angular Deviation
(mm)
5.3 Installing the Brake
The following steps detail installing the COMBISTOP brake. For visual examples of
installing the brake and adjusting the air gap you can view a tutorial video at the following
link.
The following images show a cross view of a fully assembled brake, both with flange and
with friction disk.
Figure 3 Brake with Flange
1.
If using a friction disk (4) or flange (5), install the disk/flange directly onto the motor
bearing assembly or other mounting surface.
2.
If using a dust protection ring (7), install the ring onto the friction disk/flange.
3.
Slide the hub (2) onto the drive shaft as shown below.
24
02
03
04
05
0.2
0.4
0.4
0.4
0.04
0.04
0.05
0.05
Installation Video on Youtube
COMBISTOP Installation Video
06
07
08
09
0.4
0.5
0.5
0.5
0.06
0.06
0.08
0.08
Figure 4 Brake with Friction Disk
2021 KEB America, Inc.
©
10
11
0.5
0.6
0.08
0.1
Advertisement
Table of Contents
Troubleshooting
